Welcome![Sign In][Sign Up]
Location:
Search - bootloader usb

Search list

[Other resource2440boot_rev0

Description: 2440的bootloader,用来载入你的用户程序(非系统代码),晶振16MHz,主频Fclk=256MHz,usb时钟为48MHz.
Platform: | Size: 41844 | Author: 樊韬 | Hits:

[Other resourcelJD2410DVK-I_TEST

Description: S3C2410的底层Bootloader的测试程序,有相应的USB驱动程序
Platform: | Size: 8225549 | Author: jiangling | Hits:

[Other resource2410mon

Description: 根据三星公司提供的在linux环境下的bootloader vivi,经过重新组合变成在ADS1.2环境下编译,并增加了USB下载功能。此源码作为监控程序,烧录在NORFLASH里面,作为专用下载软件使用。
Platform: | Size: 552887 | Author: liumao | Hits:

[Other resourceWince_2410_bsp

Description: s3c2410,WinCE的完整BSP包,包含bootloader,driver:atapi,CANBus,CS8900,LCD,flash,USB,touch,
Platform: | Size: 3447614 | Author: zkrain | Hits:

[Embeded-SCM Developmcp sd reader

Description: This demo uses the selected hardware platform as an SD card reader. Connect the hardware platform to a computer through a USB cable. To run this project, you will need to load the corresponding firmware into the devices. There are two methods available for loading the demos: Precompiled demos and source code projects. Precompiled Demos are available in the “\USB – Precompiled Demos” folders. Each demo should be prefaced with the hardware platform it is compiled for. Select the file that matches the hardware that you have and the demo that you want to run. For more information about how to load a precompiled project, please see the “Getting Started – Loading a precompiled demo” guide. The source code for this demo is available in the “Topics…->MPLAB IDE). Please note that when using either the C30 or C32 demo projects you will be required to select the correct processor for the demo board. 1) Open the associated project file 2) In MPLAB Select “Configure->Select Device” 3) In the device list box in the top left corner of that window, select the desired device. NOTE WHEN USING THE HID BOOTLOADER (for PIC18F87J50 PIM): The “USB Device - Mass Storage - SD Card reader” and “USB Device - Mass Storage - SD Card data logger” demos make use of the SD Card PICtail Daughter Board (Microchip® Direct: AC164122). This PICtail uses the RB4 I/O pin for the card detect (CD) signal, and is actively driven by the PICtail. The active drive overpowers the pull up resistor on the RB4 pushbutton (on the PIC18F87J50 FS USB Plug-In Module board). As a result, if the PIC18F87J50 is programmed with the HID bootloader, and an SD Card is installed in the socket when the microcontroller comes out of reset, the firmware will immediately enter the bootloader (irrespective of the RB4 pushbutton state). To exit the bootloader firmware, remove the SD Card from the SD Card socket, and tap the MCLR button. When the SD Card is not plugged in, the PICtail will drive the card detect signal (which is connected to RB4) logic high, which will enable the bootloader to exit to the main application after coming out of reset. Once the main application firmware is operating, the SD Card can be plugged in. The SD Card is “hot-swappable” and should be recognized by the host upon insertion. To avoid this inconvenience when using the bootloader with the PICtail, it is suggested to modify the bootloader firmware to use some other I/O pin for bootloader entry, such as RB0 (which has a pushbutton on it on the HPC Explorer board).
Platform: | Size: 773398 | Author: bluntpig | Hits:

[Com Portmscomm

Description: 介绍利用VB6串行通信编程的方法,对采用了RS-232接口的仪器进行串行通信的计算机测控软件开发,以及实现仪器功能和指标的验收。-Introduce the use of VB6 programming serial communication method, using the RS-232 interface for serial communication equipment computer monitoring and control software development, as well as functional instruments and indicators to achieve acceptance.
Platform: | Size: 1024 | Author: camus_lee | Hits:

[SCMZLG_can

Description: 这款程序是关于can总线的,对于can总线的初学者会有很大的帮助。-This procedure is on the can bus, the bus can be very helpful to beginners.
Platform: | Size: 86016 | Author: louxiuqun | Hits:

[Embeded LinuxlJD2410DVK-I_TEST

Description: S3C2410的底层Bootloader的测试程序,有相应的USB驱动程序-S3C2410 bottom Bootloader test procedures, has the corresponding USB driver
Platform: | Size: 8225792 | Author: jiangling | Hits:

[Embeded-SCM DevelopYLP2410_BIOS

Description: ylp2410的bootloader源码,支持串口和usb下载映象文件,经过测试的,很好用-ylp2410 the bootloader source, support serial and usb download image files, tested, very good use
Platform: | Size: 408576 | Author: jpyy | Hits:

[Embeded Linuxlinux_usbd.tar

Description: 该程序对VIVI扩展了USB下载功能,能够在S3C2410上通过USB下载bootloader,kernel,rootfs,主机环境是了linux。类似minicom,但是速度要远远快于minicom。 -Similar minicom, but the speed is much faster than minicom.
Platform: | Size: 438272 | Author: lby | Hits:

[SCMan200sw

Description: USB Bootloader 通过USB更新固件程序-USB Bootloader Update Firmware through USB
Platform: | Size: 979968 | Author: 未央生 | Hits:

[Embeded-SCM DevelopbootloaderOK2

Description: 本代bootloader通过usb下载代码首先存放在sdram中,然后拷贝到dataflash中并加载。本代码经过反复测试,准确无误,绝对可靠。环境IAR-This generation through usb download bootloader code stored in the sdram of the first, and then copied to and loaded in dataflash. After repeated testing of the code, accurate, absolutely reliable. IAR environment
Platform: | Size: 3937280 | Author: like | Hits:

[Embeded LinuxGEC2440

Description: 广嵌公司的开发板的开发手册,实战手册, 源码清晰明了,学习嵌入式低成驱动的必备佳品,基于s3c2440处理器,有usb,串口等常用外设的驱动,以及bootloader——vivi的改写和移置-Canton embedded development board' s development of manuals, combat manuals, source clarity, learning-driven low-cost embedded Jiapin necessary, based on the s3c2440 processor, a usb, serial peripherals, such as drivers commonly used, as well as the bootloader-- vivi rewritten and relocated
Platform: | Size: 7137280 | Author: netyangarm | Hits:

[Linux-Unixbootloader_for_AT91SAM7

Description: AT91SAM7XX USB bootloader
Platform: | Size: 41984 | Author: Steven Liao | Hits:

[Embeded-SCM Developboot_usb

Description: TI Cortex M3系列通过USB boot的例子程序-Cortext M3 Bootloader via USB
Platform: | Size: 84992 | Author: zh | Hits:

[ARM-PowerPC-ColdFire-MIPSNANDFlash

Description: 主要包含了Freescale的i.MX21的bootloader,功能包括从UART或USB OTG下载镜像到8bit或16bit的NANDFLASH中启动,或者直接从NANDFLASH启动。-A bootloader for i.MX21 to boot from NANDFLASH,UART or USB OTG.
Platform: | Size: 118784 | Author: rafe | Hits:

[USB developLPC1700_USB_bootloader

Description: LPC1700 secondary USB bootloader 用USB下载固件-LPC1700 secondary USB bootloader
Platform: | Size: 703488 | Author: jhq | Hits:

[Embeded Linux2440boot

Description: 引导三星2440的Bootloader,支持USB烧写内核-Samsung 2440 to guide the Bootloader, Kernel support for USB Shao Xie
Platform: | Size: 436224 | Author: guofengxiao | Hits:

[Embeded-SCM DevelopUSB_Bootloader_Source_Code

Description: USB Bootloader Source Code for LPC3-USB Bootloader Source Code for LPC3xxx
Platform: | Size: 96256 | Author: GTrD | Hits:

[USB developtiny45usbbootloader

Description: usb cdc bootloader for tiny
Platform: | Size: 24576 | Author: satserg | Hits:
« 1 2 3 4 5 6 78 9 »

CodeBus www.codebus.net